Stauff Corp.

Articles About Stauff Corp.


Articles are sorted by RELEVANCE. Sort by Date.

1 Industry News (September 2017)

The complete Industry News section from the September 2017 issue of Power Transmission Engineering.

2 IMTS 2016 Booth Preview (August 2016)

A nose-in-the-tent peek at the booths featuring mechanical motion components.

3 Planning Ahead (April 2019)

Navigating Clutch/Brake Operation in Harsh Environmental Conditions: Chemicals, saltwater, food particles, heat, dust, and electrical corrosion are just a few of the many issues that can cause clutches and brakes to fail prematurely.

4 An Overview of Fretting Wear (April 2021)

The reasons of this failure, its consequences and mitigation methods.

5 Industry News (Fall 2007)

news froma round the Industry

6 Engineering Showcase 2015 (March 2015)

One of our goals at Power Transmission Engineering is to help you understand, identify and select the best technology for your mechanical power transmission or motion control applications. With every project, you have to decide which components to use, and which suppliers, based on functionality, quality and price. We aim to help you make those decisions informed by providing the latest information on current technology, especially when it comes to mechanical components.

7 Product News (April 2011)

The complete Product News section from the April 2011 issue of Power Transmission Engineering.

8 Influence of Gear Loads on Spline Couplings (February 2014)

Involute splines are commonly used in gearboxes to connect gears and shafts, especially when high torque is transmitted through the coupling. The load is shared among multiple teeth around the coupling circumference, resulting in higher load capacity than a conventional single key. However, the total load is not equally shared among all spline teeth, mainly because of pitch deviations resulting from the manufacturing process. The load distribution along the spline engagement length is also nonuniform because of tooth misalignments and shaft torsional effects. This paper presents an investigation of the influence of spur gear loads on the load distribution of spline teeth.

9 Product News (October 2014)

News about new Products in the industry.

10 Wind Pushing Future of Mechanical Components (April 2015)

After a sluggish 2013, annual installations of new wind turbines grew by 44% in 2014, according to the Global Wind Energy Council. And while much of that growth has been in Asia— particularly China, which now leads the world with 114 GW of installed capacity—the USA, Europe, and the rest of the world expect steady growth for the next couple of years as well (Fig. 1).