Standard Locknut

Articles About Standard Locknut


Articles are sorted by RELEVANCE. Sort by Date.

1 Industry News (September 2017)

The complete Industry News section from the September 2017 issue of Power Transmission Engineering.

2 Baldor Motor Basics: Electric Motors and Power Systems and Electric Motors and Voltage (September 2017)

Part 1: There seems to be a lot of confusion about the voltage standards for motors and why they are structured the way they are. Part 2: The effect of low voltage on electric motors is pretty widely known and understood, but the effect of high voltage on motors is frequently misunderstood.

3 Gear Design (December 2017)

Our expert explores standard vs. optimized gears, as well as high contact ratio gearing.

4 Product News (March 2018)

The complete Product News section from the March 2018 issue of Power Transmission Engineering.

5 ISO 281:2007 - Caveat Emptor (October 2016)

I was invited by Tom Astrene of TLT to write a response to the July 2010 TLT article (Ref. 1). My rebuttal — “In Search of a Fatigue Limit: A Critique of ISO Standard 281:2007” — was published in Tribology and Lubrication Engineering, TLT, August 2010 edition (Ref. 10). While this article is also available online, I will attempt to summarize the essence of my response.

6 Load Ratings & Bearing Life (March 2016)

Power Transmission Engineering is collaborating with the Bearing Specialists Association (BSA) on a special section within the magazine. Bearing Briefs will present updated reports on bearing topics for each issue in 2016. Complimentary access to all BSA Bearing and Industry Briefs is available on the BSA website at www.bsahome.org/tools.

7 Not All Thin-Section Bearings Are Created Equal (February 2011)

American Bearing Manufacturers Association (ABMA) Standard 9 and ISO 281 give equations for calculating the basic dynamic radial load rating for ball bearings. These equations are based on a number of assumptions, many of which are not valid for thin-section bearings. (Thin-section bearings are described in ABMA standard 26.2.) Nevertheless, many thin-section bearing catalogs report load ratings based on these equations. Kaydon has developed a new method for calculating the dynamic radial load rating for thin-section ball bearings. The new method uses the contact stress and the number of stress-cycles-per-revolution to calculate the capacity. The new numbers are based on five years of actual test results. These equations can also be used to calculate the dynamic radial load rating for four-point contact ball bearings, which are not covered in ABMA standard 9 or ISO 281.

8 Specifying a Gear - Ask the Expert (February 2014)

A reader asks what are the required parameters to properly specify a gear.

9 Evolution of Worm Gear Standards and their Consequences on Load Capacity Calculation Approach (September 2014)

Beginning with a brief summary and update of the latest advances in the calculation methods for worm gears, the author then presents the detailed approach to worm gear geometry found in the revised ISO TR 10828. With that information, and by presenting examples, these new methods are explained, as are their possibilities for addressing the geometrical particularities of worm gears and their impact upon the behavior and load capacity of a gearset under working conditions based on ISO TR 14521 — Methods B and C. The author also highlights the new possibilities offered on that basis for the further evolution of load capacity calculation of a worm gearset based on load and contact pressure distribution.

News Items About Standard Locknut

1 Standard Locknut Welcomes Director of Distribution Sales (May 22, 2018)
Kevin Decker has joined Standard Locknut LLC as director of distribution sales. Decker is assuming a new role at Standard Locknut respo...

2 Standard Locknut Introduces VP of Sales and Marketing (August 9, 2017)
David White has joined Standard Locknut LLC as vice president of sales and marketing.  In this role, White will drive Standard Lockn...